Husqvarna K 770 Dry Cut Bedienungsanweisung Seite 22

6. Put your right foot on the lower section of the rear
handle to push the product against the ground.
WARNING: Do not wind the starter rope
around your hand.
7. Pull the starter rope slowly until you feel a resistance
as the starter pawls engage. Then pull continuously
and quickly.
CAUTION: Do not pull the starter rope
fully and do not let go of the starter rope
handle when the starter rope is
extended. This can cause damage to the
product.
8. Push the throttle trigger to disengage the start
throttle and set the product at idle speed.
To stop the product
WARNING: The cutting blade continues to
rotate up to a minute after the motor stops
(known as blade coasting). Make sure that
the cutting blade can rotate freely until it
completely stops. Carelessness can cause
serious personal injury.
22
• Move the STOP switch to the right to stop the
engine.
To use a dust bag
1. Examine the dust equipment. Refer to
the dust equipment on page 16 .
2. Make sure that the dust bag inlet is at a lower
position than the product during operation.
3. Make sure that the dust bag does not tilt. Make sure
that the dust bag inlet is as near the ground as
possible.
To remove dust from the dust bag
WARNING: Put on protective glasses,
gloves and approved respiratory protection.
Do not open the dust bag unless it is in a
garbage bag. Dust can spill into the air when
the operator removes and cleans the dust
To examine
861 - 003 - 12.11.2018