Setting The Dip Switch - Sony UY-S100 Bedienungsanleitung

Setting the DIP Switch

10
(GB)
The DIP switches on the rear panel determine the on/off state of the
internal SCSI bus terminator and SCSI device ID number.
The DIP switches are preset at the factory to "2" as shown below.
ON
OFF
Note
Turn off the power before changing the DIP switch setting.
TERMINATOR ON/OFF setting
ON: If the scanner is located at the end of the SCSI bus, this switch should
be set to ON. The internal terminator is ON.
OFF: If another device is at the end of the bus, this switch should be OFF.
SCSI ID setting
The SCSI ID selection must be different from any other device on the bus.
If two SCSI ID devices have the same ID, a malfunction will occur.
SCSI ID SCSI ID switches
0
0 0 0
1
0 0
2
2
0
2 1
3
0
4
4
0 0
4
5
0
4 2
6
4 2 1
7
TERMINATOR
SCSI ID
4 2 1
0 0 0
1
0
1
0