Deleting A Timer; The All On/All Off Feature - Silvercrest SFB 10.1 C3 Bedienungsanleitung Und Serviceinformationen

SilverCrest SFB 10.1 C3
The timer is always set in 24-hour format. If you have set
the remote control preferences to the 12-hour format,
please note the following:
In this case the remote control automatically converts the
24-hour format to the 12-hour format. Example: To
program a timer for 03:30PM, enter 15:30.
5. Next press the device button for the device you want and then enter
the command sequence (max. 14 buttons) that you want to send at
the set time.
It is necessary to press a device button before entering a command
sequence, otherwise the display reads "ERROR KEY".
6. By default, the different timer commands are transmitted sequentially
every second. As this could be too fast for some devices, you can
adjust the delay time in 2-second increments from 5 to 21 seconds.
To do so, press the
current delay time is indicated on the display.
7. When you are done, press
reads "SUCCESS".
8. You can press up to 15 buttons per event timer, including the device
button. After this, the programming is applied automatically and the
display reads "SUCCESS".
9. If required, you can program more event timers.
10. When an event timer is programmed, the
of the display.
After an event timer has completed it is erased automatically.
Press to go back one menu level. To return to the start window,
press one of the device buttons.

Deleting a timer

To delete a programmed timer ("SLEEP TIMER", "TIMER1" to "TIMER4"):
1. Press and hold the
2. Press
3. Select the timer that you wish to delete and press
display reads "CLEAR". Press
"SUCCESS". The selected timer is deleted. The display shows the
name of the selected timer ("SLEEP TIMER", "TIMER1" to "TIMER4").
Press to go back one menu level. To return to the start window,
press one of the device buttons.

The All on/All off feature

If you have programmed your remote control to control several devices,
this feature lets you switch all of them on or off at the same time by just
pressing one button. To do so, press and hold the
a few seconds. This switches all the devices on or off at the same time.
Depending on the number of devices programmed, this can take up to 10
seconds. The following is required for this feature to work:
90 - English
button, more than once, if necessary. The
button for at least 3 seconds.
, select "TIMER" and press
to confirm your entry. The display
icon appears on the left
to confirm. The display reads
to confirm.
to confirm. The
button (3) for