Blaupunkt CMP301 Bedienungsanleitung Seite 7

CMP301
1. On/Off switch
2. Coffee switch
3. Steam switch
4. Cup cushion
5. Drip tray
6. Steam control knob
7. Water tank cover
8. Detachable water tank
Before first use
It is recommended to rinse the coffee maker before the first use. The coffee maker should also be
rinsed after a longer period of time without use. Refer to the instruction in the "Cleaning and
maintenance" chapter.
NOTE: When water system is empty, the water pump may work louder and device may vibrate more.
This is a common occurrence which will disappear after a given period of time.
Preparation of espresso coffee
1. Turn device on by pressing the On/Off switch [1]. Coffee maker will start to pre-heat, LED will
blink.
2. Choose the right filter [14 ] (for one cup, for two cups) and put it into the filter holder [16]
3. When coffee maker is ready, the LED will stop blinking and shine continuously.
4. Hold the filter holder [16] with filter inside [14] below the mounting point [12] and rinse it
with water to pre-heat it. Press the button "coffee switch" [2] and wait for a few seconds, than
press "coffee switch" again to close the flow of the water.
5. Pour medium ground coffee powder into the filter [14] and pack the coffee gently. Clean the
rim of the filter holder [16] to remove any excess ground coffee.
ADVISE 1. Coffee ground too fine (like for brewed coffee), will block the flow of the water in
the filter. Coffee ground too coarse, will not release the full flavor and aroma of the coffee.
ADVISE 2. If coffee is packed too tightly, the flow of water can be obstructedand may scold
the coffee and cause the drink to have a burned aroma. It may even block the flow of water
totally. If the coffee is packed too loose it will not transfer enough taste and aroma into the
drink.
6. Place the filter holder [16] into the mounting point head [12]. Engravings on the filter holder
must fit in the slots of the filter holder's mounting point. Turn the filter holder all the way to
the right (clockwise).
7. Place cups under the outlets of the filter holder.
8. Press "coffee switch" [2] and wait for the right amount of coffee to pour into the cups
thenpress "coffee switch" [2] again.
Frothing milk
It is advised to froth the milk after the coffee had been prepared as milk frothing mode requires a
higher temperature. After milk frothing it is necessary to wait a minimum of 5 minutes to allow the
device to cool down slightly. If the temperature of brewing is too high, the coffee can be scolded which
will cause the coffee to have a burned and bitter taste and aroma.
Before frothing ensure the volume of milk is adequate in the cup. Milk can double in volume after
9. Cup warmer
10. Steam tube
11. Steam tube jacket
12. Filter holder's mounting point
13. Filter holder handle
14. Stainless steel filter
15. Press bar with spoon
16. Filter holder
5