Klarstein 10031201 Anschluss- Und Anwendungshinweise Seite 11

b) If the adjustment of bracket as per above step (a) still doesn't fit your grill, loosen
the 3 screws that hold together Part X & Y (Fig 3-1). Turn Part X upside down and reas-
semble it to Part Y, making the whole bracket a "U" shape as shown in Fig 3-1 through
Fig 3-5. (Make sure to assemble the "U" shape bracket in the correct method as shown
in Fig 3-4 NOTICE). Remember to place a washer before placing a nut. Secure bolts
with nuts. If it still doesn't fit your grill, remove Part Z from the bracket and mount the
motor on Part Y directly (Fig 3-6).
3. Slide rotisserie motor over bracket.
(Fig 4)
4. Assembly the two sections of rotis-
serie rod. Make sure the two sec-
tions are tightly secured to avoid
them turning loose during use. (Fig
5)
5. Place the rotisserie prongs into the
rotisserie rod with caution. (Fig 6)
6. Place the collar into the rotisserie
rod and fix it on the support on the
spit rod bracket that is put on the
grill. The rod will turn smoothly.
(Fig 7)
11