Troubleshooting - Panasonic EW-DL83 Betriebsanleitung

Troubleshooting

Problem
The charge status lamp (
does not glow when charging
starts.
The charge status lamp (
is blinking rapidly.
(Twice every second)
The toothbrush can only be
used for a few minutes, even if
it is charged.
The battery capacity lamp (
turns off without blinking.
The toothbrush does not
operate.
The toothbrush stops operating
every once in a while.
The vibration increases
gradually when pressing the
power switch.
The toothbrush shaft moves.
If the problems still cannot be solved, contact the store where you purchased the unit or a service centre authorized by Panasonic for repair.
EW-DL83_EU.indb 17
Possible cause
You have just purchased the toothbrush or
)
have not used it for a while.
The main unit is not properly mounted on the
charging stand.
)
The temperature is too low or high while
charging.
The main unit is not properly mounted on the
charging stand.
The rechargeable battery has reached its
)
operating life. (Approx. 3 years)
The appliance is used with approximately
5 °C or lower.
The "30‑second brushing notification timer
function" is in operation. (See page 12.)
The "Soft start function" is in operation.
(See page 12.)
Action
The charge status lamp ( ) may not glow for
several minutes after starting to charge it, but it will
glow if you continue to charge it. If the charge
status lamp ( ) does not glow after a while,
consult with an authorized service centre for repair.
Insert the main unit in the charging ring and check that
the charge status lamp ( ) glows. (See page 11.)
Charge the toothbrush within the recommended
charging temperature of 5 °C to 35 °C.
If the charge status lamp ( ) blinks even when
charging within the recommended temperature range,
please contact an authorized service centre for repair.
Insert the main unit in the charging ring and check that
the charge status lamp ( ) glows. (See page 11.)
Replace the battery. (See page 18.)
Contact the authorized service centre where
purchased.
Do not use the appliance with approximately 5 °C
or lower.
This is not a malfunction.
Continue using it.
This is not a malfunction.
Continue using it.
This is not a malfunction. (See page 13.)
17
2015/12/14 14:30:40