Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Using the Transport Box
Open the lid (3) at the rear side of the transport box and remove the
ratchet with hook (1) from the upper storage compartment of the box.
Fold the crank (6) by 180° so it can be used as a crank to roll out the
belt (2). Roll out the belt completely.
After use store the ratchet with hook (1) in the corresponding storage
compartment. Roll up the belt on the roll. Put the hook into the hook
compartment at the bottom side of the transport box. Close the lid.
Transport boxes can be hooked up using the box connector (4) to save
space.
Tie Down
1. Put the belt across/around the load you intend to fasten and secure the
belt with the hook on the other end, e.g. on the trailer. Fasten the other
hook on the trailer.
2. Slide the belt through the slot A (see figure) and pull the belt to fasten
the load. In order to tie down the load, move the ratchet B forth and
back until the belt is tightly tensed.
3. Fold down the ratchet B to lock the belt. Before using the ratchet tie
down, observe that there are at least 1.5 windings (max. 3 windings) of
the belt on the ratchet (inner roll with slot) to prevent the belt from
slipping out of the ratchet.
Loosen
1. Push up/pull the lock C and tilt down the ratchet B at the same time
until the ratchet is in a horizontal position. The locking mechanism of
the inner roll with slot is released.
2. Now you can slack off the belt and pull the belt out.
Technical Data
Belt Width: 25 mm
Lashing Capacity LC: 250 daN ..............
Hand Force S
HF
Standard Tension Force S
.................
: 25 daN
.................
: 25 daN ≤ S
TF
Using
Material: Polyester (PES)
Total Length: 5 m
Max. Elongation: 7 %
≤ 125 daN
TF
IX
Werbung
Inhaltsverzeichnis
