Powering The Transmitter Cradle Using Batteries - Silvercrest RFH 2401 Bedienungsanleitung Und Serviceinformationen

Powering the Transmitter Cradle Using Batteries

The transmitter cradle battery compartment is located on the bottom.
1. Remove any cable connections and turn the transmitter cradle upside
down, holding it in your hand.
2. Open the battery compartment by sliding the lock of the compartment
cover into the direction of the compartment. The cover can be opened
and then removed.
3. Insert three AAA batteries into the battery compartment. Note the + and
– icons on the batteries and inside the battery compartment.
4. Place the battery compartment cover over the battery compartment so
that the locking nose of the cover is inserted into the corresponding
notch on the transmitter cradle. Then close the battery compartment
cover until it locks in place.
If you have inserted batteries into the transmitter cradle and
you connect the power adapter to the power socket (12),
battery operation will be disabled automatically. This helps
you to save battery power whenever the device is connected
to the mains via the power adapter.
While the transmitter cradle is on battery power, it will not
charge the built-in headphone battery.
20
SilverCrest RFH 2401
English