Hama Black Thunder Bedienungsanleitung Seite 4

3. Before Getting Started
Note
Before using the charging station for the first
time, decide which attachment method you are
going to use.
4. Getting Started and Operation
Note
• Before using the 3M adhesive pad, ensure that
the surface of the intended place of installation
is suitable. Extremely delicate surface coatings
(such as paint or lacquer finish) can be
damaged and flake off when the adhesive pad
is removed.
• Do not place the adhesive pad over the product
label, since this may cover up important
information about the product that you may
need in the future (e.g. for receiving customer
support).
• Then peel off the foil with Nitto No.5000NS printed
on it. Finally, press the charging station onto the
spot where you wish it to remain.
Note
If the power draw of all the connected devices
exceeds the maximum performance (see section
8) of the charging station, the connected devices
may charge more slowly or even not charge at all.
5. Product information
Behaviour of the charge indicator LEDs (C & D)
LED behaviour
Red
Blue
LEDs off (with
power supply on)
LEDs off (with
power supply off)
Brief flashing
6. Warranty Disclaimer
Hama GmbH & Co. KG assumes no liability and
provides no warranty for damage resulting from
improper installation/mounting, improper use of
the product or from failure to observe the operating
instructions and/or safety notes.
Meaning
Actively charging: The
battery of the controller is
not yet fully charged.
Recharging completed:
The battery of the
controller is fully charged.
Power saving mode: The
charging process was
completed more than 5
minutes ago. The battery
of the controller is fully
charged.
The charging station is
switched off.
The charging station was
just connected to a power
source and is now ready
for use.
3