Inhaltsverzeichnis
Werbung
Tools required for Assembling
10 mm & 13 mm wrenches (included)
Cross-head screwdrivers
Assembling
1. Before assembling, check the material for com-
pleteness (refer to the parts list).
2. Use the cross-head screws (10), the washers (11)
and the nuts (15) to assemble the crossbars (4)
with the leg frames (6) and (7). This way you as-
semble the tabletop support (figure 1).
3. Place both worktops (2) and (3) with the small bore
holes facing up on a flat level and clean surface
(e.g. workbench). Use the wood screws (16) to
attach the crank handle units (8) as pictured in
figure 2, to the worktops.
4. Fit the assembled leg frames into the crank handle
units (8). Line up the holes in the crank handles
units with the holes in the leg frames. Insert the
hex bolts (14) and the washers (12) from outside of
the crank handle units. Attach washers (12) and
nuts (13) from the inside (figure 3).
5. Attach plastic foot caps (5) on each table leg end
of the leg frames (6) and (7). Pay attention to at-
tach each cap with the longest side at the outer
corner.
6. Select suitable holes on the worktops to fix the four
chocks (1). The chocks can be removed and repo-
sitioned at any time.
Assembly Instruction
7
1
2
3
Werbung
Inhaltsverzeichnis
