Tool Fitting; Initial Operation - Westfalia 82 38 70 Bedienungsanleitung

Tool Fitting

1. Always unplug the tool before installing or exchanging the tool bit!
2. To insert a tool bit e.g. a wire brush (G), press the locking button (3). Use the
provided collet chuck key (A) to turn the locknut of the tool holder (1) counter
clockwise to loosen.
3. Insert the selected tool into the chuck as far as it will go and firmly tighten the
locknut, while holding down the locking button (3).
3

Initial Operation

1. Ensure that the ON/OFF switch (4) is switched off.
2. Then plug in the tool.
3. Use the ON/OFF switch to switch on the tool. The unit starts up.
4. Use the rotation speed regulator (5) to setup the desired no-load rotation
speed. The proper speed depends on the tool used and the type of material to
be processed.
5. The correct way to hold the machine is to grasp the casing firmly with thumb
and index finger, just like holding a pen. Take care not to cover the ventilation
slots on the side cover of the machine. A whining start up noise is normal and
no reason to worry.
Operation
Locknut
R
12
G
A