Notes On Safety; Symbols And Icons - Parkside PMNF 1350 C3 Originalbetriebsanleitung

GB IE NI
Cutting disc (included):
Idling speed n
0
................................... max.12250 min
Disc speed ....................... max. 80 m/s*
Outer diameter ................... Ø 125 mm
Bore hole ........................ Ø 22,23 mm
*
The grinding disc must keep a rotational
speed of 80 m/s.
Levels of noise and vibration were determi-
ned according to the norms and regulations
in the declaration of conformity.
The vibration emission value has been mea-
sured according to a standardised testing
method and may be used for comparison
with another electric tool.
The indicated vibration emission value may
also be used for an introductory assessment
of the exposure.
Warning:
The vibration emission value whilst
actually using the electrical tool may
vary from the given values indepen-
dently of the type and way in which
the electric tool is used.
Try to keep the exposure to vibra-
tions as low as possible. Examples
of measures to reduce vibration
exposure are the wearing of gloves
when using the tool and limiting the
working hours. For this purpose all
parts of the operating cycle have to
be considered (for example, times
when the electric tool is switched off
and times when it is switched on but
running without any load).

Notes on safety

Caution! When using power tools,
observe the following basic safety
6
measures for the prevention of electric
shocks and the risk of injury and fire.
Please read all these instructions be-
-1
fore using this electric tool and please
keep the safety instructions.

Symbols and icons

Symbols on the device:
Warning!
Warning! Electric shock hazard.
Always unplug the device before
working on it.
Read the manual!
Wear eye and ear protection.
Wear breathing protection.
Risk of cuts!
Wear cut-resistant gloves.
Wear safety shoes.
Do not use for wet grinding.
Safety class II (Double insulation).
Electrical machines do not belong
with domestic waste.
Other symbols on the
cutting disc:
Do not use defective discs.
Symbols used in the instructions:
Hazard symbols with informa-
tion on prevention of personal
injury and property damage.