Inhaltsverzeichnis
Werbung
Operation
Inserting a Glue Stick
Insert a glue stick into the rear end of the glue gun and push it in as far as you
can. Press the trigger to make sure that the stick is solidly pressed against the
heater unit.
Operation
Connect the unit to a power outlet. The power LED lights up and the glue gun
immediately starts to heat up. Set the glue gun on its wire support and wait
until some glue is molten and appears in the nozzle. When the trigger is
pressed molten glue is forced out of the nozzle. Put some molten glue onto the
dry, clean surface you want to use and immediately press the work piece you
want to glue down into the molten glue. The glue solidifies almost immediately
and forms an instant bond.
After use molten glue can remain in the glue gun, it will be melted again when
the unit is used the next time.
4
Werbung
Inhaltsverzeichnis
