Product Description; Charging Modes - AEG LP 3.8 Bedienungsanleitung

16

proDUCt DEsCriptioN

Intended use
the charger is intended for charging, float charging
and regenerating 12 V direct current batteries (only
rechargeable, maintenance-free, sealed batteries or
lead-acid batteries (sLa)), as they are installed in cars,
ships, trucks and other vehicles. this includes different
types of lead-acid:
▪
wet cell batteries / sealed leadacid batteries (liquid
electrolyte)
▪
gel batteries (gel-like electrolyte)
▪
agm batteries (electrolyte in fibreglass fleece)
▪
maintenance-free batteries and VrLa batteries
(lead-acid batteries with overpressure valve)
the charger can be connected directly to the bat-
tery using the clamps. the charger is not designed to
charge any batteries other than those stated above. it
is exclusively certified for private use. any other use or
modification to the device is considered as nonintend-
ed and bears considerable dangers. the manufacturer
accepts no responsibility for any damages arising from
non-intended use.
Performance characteristics
▪
With micro-processor
▪
Charger for all common 12 V vehicle batteries
▪
3800 ma maximum charging capacity
▪
intelligent 5-level charge cycle
(iiUoiUp characteristic)
▪
Not necessary to uninstall the battery
▪
Fully automated charging, diagnosis, recovery and
maintenance function
▪
With comfort connection
▪
ideal for seasonal vehicles such as convertibles or
motorcycles
▪
safe and easy application
Product Overview
9
1 2
3
7
6
5
8
1. power plug 6. terminal cable (-)
2. power cable (black) with ring
3. Battery charger terminal
4. Control and display 7. terminal cable (+) with
panel clamp (red)
5. terminal cable (+) 8. terminal cable (-) with
(red) with ring terminal clamp (black)
9. mounting apertures
Technical data
maximum 3800 ma
charging
capacity
Charging 5-level (iiUoiUp characteristic)
characteristic
For battery types gel, agm, lead acid,
maintenance-free and
4
low-maintenance batteries
Battery voltage 12 V
operating volt- 230 V aC
age
recommended 1.2 - 120 ah
for battery
capacity
Display LED (charging progress etc.)
safety features overloading, short circuit,
overheating and voltage reversal
protection as well as anti-spark
and electronic-proof (no damage
of sensitive on-board electronics)
Fuse
the (+) pole connector cable (red) with a ring con-
nector is secured with a flat plug-in fuse (10 a). it is
activated in the case of short circuits or voltage peaks
and must be replaced subsequently.
Change fuse:
Attention! Do not install a stronger fuse. otherwise
the electronics could be damaged.
1. open the protective casing
2. remove the defective flat plug-in fuse
3. insert a new flat plug-in fuse of the same size (10 a)
into the slot
4. Close the protective casing once again
GB
iNDiCatioNs /

CHargiNg moDEs

9 10 11
16 15 14 13 12
9 Charging mode 14.4 V / 0.8 a max
suitable for charging
small batteries < 14 ah
10 Charging mode 14.4 V / 3.8 a max
suitable for charging large batteries in
normal conditions (normally used for
WEt, mF and most gEL batteries).
11 Charging mode 14.7 V / 3.8 a max
suitable for charging large batteries
in sub-zero temperatures and several
agm batteries with capacity of more
than 14 ah.
12 Fault!
incorrect polarity
13 Fully charged
14 Charging in progress
15 Before charging mode selection and
in case of open circuit, short circuit or
reverse connection.
16 „mode" selection button
17