Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
pal_hpds_lamp_guide_bat2_pal_hpds_lamp_guide 18/08/11 11:14 Page5
2 How to use the Philips LED Inspection lamp
2.1
Electrical connection
Important
Philips LED
Inspection lamp docking station
has a wide-range power supply
input voltage.
From 100~120V AC to
200~240V AC.
2.1.1
Connect the power
cord to the docking station and
plug it into the electrical outlet.
2.1.2
Before you use
Philips LED Inspection
lamp for the first time
• Charge the device on your
docking station for 6 hours.
Important
Maximum
autonomy may be reached after
2 complete charge-discharge
cycles.
5
Danger
Before you turn the Philips LED
Inspection lamp ON, make sure
it is turned away from anyone's
direct vision.
2.2
How to use the LED
light and UV-A modes
2.2.1
To use the LED light
6 h
• To turn on/off, press the
power button on the back of
the Philips LED Inspection lamp
briefly.
• Use may use the flexible
magnet holder or the 360°
retractable hook to install
your LED inspection lamp
where and how needed.
2.2.2
To use the UV-A
mode
UV-A
UV-A
• To turn the UVA-mode
on, press the power button for
at least 3 seconds.
• To turn the UV-A mode off,
press briefly.
UV-A
UV-A
The UV-A mode lets you
detect motor fluid leaks quickly
and easily.
Note
For best results, confirm
leaks with a tracer.
Werbung
Inhaltsverzeichnis
