Blaupunkt Bluebot Kurzanleitung Seite 4

The backside of the docking station contains adhesive tape. You can chose if you want to attach the docking
station or not. For optimum stability of the docking station its recommended to fix it onto the wall. If you
want to attach the docking station to a fixed location, please peel off the protection film at the back and press
the docking station onto the wall. The wall or surface must be hard, smooth and clean without dust. For
example, tile, aluminium, wood or a glass surface. Otherwise it might result in less good fixing onto the wall.
The adhesive tape is removable and can be reused.
Which cleaning programs can I use?
Mode 1111: Spot cleaning. Bluebot will clean in circles when it locates excessive dirt. You can also activate the
program by pressing the 'SPOT'-button on the remote control when Bluebot is near excessive dirt.
Mode 2222: Automatic cleaning. Bluebot will scan the environment and decide the ideal cleaning routing.
Mode 3333: Edge cleaning. Bluebot will clean along walls and edges.
Mode 4444: Zig zag cleaning. The robot will clean in straight lines.
Press 'MODE' on the remote control while Bluebot is switched on.
How do I program a time schedule?
You can only program Bluebot when it is switched on or charging. Set Bluebot's clock: Press the 'PLAN'
button on Bluebot (located right above the text on the robot). Four LEDs will light up (HOME, ZIG-ZAG,
PLAN and the ' ' on/off button). You can now set the time, starting with the hour of the day. Press 'HOME'
to go increase numbers and 'ZIG-ZAG' to lower numbers. When the hour is set, press the '
the minutes. Adjust the numbers using the same buttons. Pressing the 'PLAN' button will cancel the procedure.
Once the time is set you can program when Bluebot should start its cleaning routine. To do so, press and
hold the 'PLAN' button for 3 seconds. Adjust the time, again using the 'HOME', 'ZIG-ZAG' and '
want Bluebot to abandon its automatic cleaning schedule, set the scheduled time "PLAN" to 00:00.
How does Bluebot recharge?
Bluebot will return to its charging base automatically and recharge. Should you want it to recharge
beforehand, simply press the 'HOME' button on the remote control. This will order Bluebot to return to the
charging base. Alternatively, you can plug the charging cord directly into Bluebot.
Warranty details
www.blaupunktrobotics.eu
Where can I nd a more extensive manual?
For the extensive Blaupunkt Bluebot manual available in German, English and Dutch language,
please visit: www.blaupunktrobotics.eu
'. You can now set
'buttons. If you