Bosch GPO 14 CE Professional Originalbetriebsanleitung Seite 21

OBJ_BUCH-1284-001.book Page 22 Tuesday, June 29, 2010 12:51 PM
22 | English
Dr. Egbert Schneider Dr. Eckerhard Strötgen
Senior Vice President Head of Product
Engineering Certification
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
27.05.2010
Assembly
Mounting the Protective Devices
Before any work on the machine itself, pull
the mains plug.
Operate your machine only with the auxilia-
ry handle 7 or bow handle 2.
Auxiliary Handle
Screw the auxiliary handle 7 on the right or left
of the machine head depending on the working
method.
Bow Handle
Fasten the bow handle 2 to the gear case as
shown in the figure.
Mounting the Grinding Tools
Before any work on the machine itself, pull
the mains plug.
Clean the grinder spindle 6 and all parts to be
mounted.
For clamping and loosening the grinding tools,
lock the grinder spindle with the spindle lock
button 3.
Actuate the spindle lock button only when
the grinder spindle is at a standstill. Other-
wise, the machine may become damaged.
See graphics page for the mounting sequence.
1 619 P09 071 | (29.6.10)
Buffing Disc
Screw the clamping mandrel 8 firmly onto grind-
er spindle 6 and tighten it via the spanner sur-
faces with an open-end spanner.
Mount the clamping flange 9 and the buffing
disc 10 onto the clamping mandrel 8. Screw on
the clamping nut 11 and tighten with the two-
pin spanner.
Polishing Plate
Mount the two spacer discs 12 and the polishing
plate 13 onto the spindle 6.
Screw on the round nut 14 and tighten with the
two-pin spanner.
Pull the lamb's wool bonnet 15 over the polish-
ing plate 13 and tighten the attachment strings.
Polishing Sponge
Screw the polishing sponge 16 firmly onto the
grinder spindle 6. The lambskin polishing bon-
net 17 can be pulled over the polishing sponge
16.
Rubber Sanding Plate
Place the rubber sanding plate 18 onto the
grinder spindle 6.
Screw on the round nut 14 and tighten with the
two-pin spanner.
Firmly press the sanding sheet 19 onto the bot-
tom side of the rubber sanding plate 18.
Felt Polishing Disc
Firmly screw the felt polishing disc 20 onto the
grinder spindle 6.
Cup Brush/Disc Brush
The cup brush/disc brush must be able to be
screwed onto the grinder spindle until it rests
firmly against the grinder spindle flange at the
end of the grinder spindle threads. Tighten the
cup brush/disc brush with an open-end span-
ner.
Bosch Power Tools