Silvercrest STS 12 B2 Bedienungsanleitung Seite 30

― The TV Simulator may not be located near a window
which could be well lit from outdoors, such as on a
busy street or next to street lights.
― There should be no additional time-controlled light
source in the room, e.g. a night light.
♦ Remove the stand by bending it slightly apart and then
pull the restraints out of the mountings.
♦ Drill two holes with a spacing of about 52 mm. Use
the stand to mark the holes: the spacing will thus be
measured correctly. The boreholes must be suitable for
8 mm wall plugs.
♦ Insert the supplied plugs into the holes and screw the
stand firmly down through the holes for wall mounting
using the supplied screws.
♦ Push the TV Simulator back onto the stand. Ensure that
the two cross-shaped restraints engage correctly with
the mountings.
CAUTION - PROPERTY DAMAGE
► Before you connect the appliance to the power sup-
ply, check to ensure that the required input voltage
as given on the type plate tallies with that for the
intended power source.
► Check to ensure that the cable for the power adapt-
er is not damaged and that it does not lead over
hot surfaces and/or sharp edges, otherwise it could
be damaged.
► Ensure that the cable for the power adapter
over-taut or kinked.
♦ Connect the power adapter
inserting the barrel connector
at the rear side of the appliance.
♦ Align the light surface
the walls and/or ceiling.
STS 12 B2
with the appliance by
into the plug socket
so that the flicker is visible on
is not
│
27 ■
GB