Installing And Connecting Up - Siemens SIMATIC NET CP 5621 Betriebsanleitung

Installing and connecting up

Note
Maximum number of CP 5621 modules in one computer
A maximum of two CP 5621 modules can be installed in one PG/PC.
Procedure
To install and connect up the CP 5621 follow the steps outlined below:
NOTICE
When handling the module, make sure that you do not touch the connectors or the
electronic components.
When installing the module make sure that you avoid electrostatic discharge (ESD)
1. Turn off your computer and pull out the power cable connector from the socket.
2. Open the computer housing as described in the manual accompanying your PG/PC.
3. Insert the CP 5621 in a PCI Express slot.
Make sure that the CP 5621 sits firmly and uniformly in the slot.
4. Close the computer housing as described in the manual accompanying your PG/PC.
5. Plug the power supply connector into the socket again and turn on your computer.
6. After you have installed the CP 5621 communications processor, the Windows plug-and-
play mechanism searches for a driver.
CP 5621
Operating Instructions (Compact), 02, A5E01156749
Installing and connecting up
4
9