Safety; General Safety Instructions; Appliance Description; Standard Delivery - AEG THERMO BODENTBS TB 50 160/1-8 Bedienung Und Installation

INSTALLATION

6. Safety

Only a qualified contractor should carry out installation,
commissioning, maintenance and repair of the appliance.
6.1

General safety instructions

We guarantee trouble-free operation and operational re-
liability only if the accessories intended for the appliance
are used.
6.2 Instructions, standards and regulations
Material losses
!
Never install the heating mat on highly or normally
flammable materials.
Material losses
!
Never switch on the heating mat when it is rolled up.
Note
Observe all applicable national and regional regula-
tions and instructions.

7. Appliance description

The heating mat is a surface heating element. The heating
mat comprises a heating conductor which is coiled over
a self-adhesive fabric.
The heating mat is glued directly to the screed or to level-
ling compound (e.g. floating screed). The heat generated
by the heating mat is thus transferred directly to the floor.
The required floor temperature is set via an external
temperature controller. The temperature controller is
equipped with a temperature sensor. The temperature
sensor must be installed at heating level.
1 2
1 Heating conductor
2 Temperature sensor
3 Conduit (tube for installing the temperature sensor)
4 Female connection for heating conductor/cold lead
5 Cold lead (electrical power cable)
The heating mat is switched on or off according to the
floor temperature set on the temperature controller.
The temperature controller takes account of heat gain,
e.g. due to sunlight or lighting, and provides frost pro-
tection.
The temperature controller is self-monitoring. In the event
of a power failure, sensor break or sensor short-circuit,
the heating automatically switches off.
3
5
4
Installation – for qualified contractors
7.1

Standard delivery

TBS TB 50 160/1-8
◦ Heating mat
◦ Two type plate labels (warranty card / main junction
box)
TBS TB 50 Set 160/1-8
◦ Heating mat
◦ Conduit (ø 10 mm) with sensor well
◦ Anti-kink bend
◦ Temperature controller FRTD 903
◦ Temperature sensor
◦ Two type plate labels (warranty card / main junction
box)
7.2 Warranty card / installation diagram
You must complete the warranty card and installation di-
agram fully. The warranty is not valid without this proof.
The chapter "Preparations" contains information on com-
pleting the installation diagram.

8. Preparations

8.1 Installation site / Installation conditions
Material losses
!
Do not install the heating mat at temperatures below
5 °C.
Note
In new builds, allow the screed to cure for 4-6 weeks.
Only install the heating mat once this period has
ended.
8.1.1 Substrate
Material losses
!
The heating mat may only be installed on floors.
Walls or ceilings may not be used as installation
surfaces.
You may install the heating mat on a variety of substrates,
e.g. screed, hot mix asphalt or moisture-resistant chip-
board. Observe the following information:
◦ Installation on hot mix asphalt: The substrate must
be able to withstand temperatures of approx. 80 °C.
◦ Installation on chipboard: Suitable insulation boards
can also be installed to improve impact sound
insulation.
◦ Very sandy screed surfaces must be coated with an
adhesive dispersion.
Thermal insulation
Thermal insulation must be fitted between the unfinished
floor and the heating mat.
» Please ensure that the thermal insulation complies
with the latest standards.
17