Connecting Of A Video Projector To Watch Digital Tv - Philips DCR 2021 Benutzerhandbuch

DCR 2021_Premiere_indice 1b
DIGITAL CONNECTION (B)
Connect the
your audio equipment using a single CINCH cable (not supplied). Consult the user
manual of your audio equipment to locate the proper digital audio input.
With this connection set up you can only control the volume (up/down and mute)
using your audio equipment remote control; refer to the user manual of your audio
equipment.
EN
4.3 Connecting of a video projector to
watch digital TV
Connect the "TV" SCART socket of your Digital-Receiver to your video projector.
Video projectors are often fed with S-Video format video signals. If this is the case
with your projector, follow the instructions below for connection and installation:
1 Connect a SCART/S-Video adapter to the "TV" SCART of your receiver (not
supplied), and connect the adapter to the S-Video input of your video projector by
means of a S-Video cable.
2 Installation: refer to chapter 10.5.2 to change the "TV/VCR SCART output" setting
of your Digital-Receiver to S-VIDEO/PAL-CVBS.
62
8/03/06 16:29
audio output socket to the relevant digital audio input socket of
Page 62