Electromagnetic Fields (Emf); Preparing For Use; Using The Appliance - Philips HR 1861 Bedienungsanleitung

- Make sure all parts are correctly mounted before you switch on the appliance.
- Only use the appliance when both clamps are locked.
- Only unlock the clamps after you have switched off the appliance and the filter has
stopped rotating.
- Do not operate the juicer for more than 40 seconds at a time when juicing heavy loads and let
it cool down sufficiently afterwards. None of the recipes in this user manual constitute
heavy loads.
- Do not remove the pulp container when the appliance is operating.
- Always unplug the appliance after use.

Electromagnetic fields (EMF)

This Philips appliance complies with all standards regarding electromagnetic fields (EMF). If handled
properly and according to the instructions in this user manual, the appliance is safe to use based on
scientific evidence available today.

preparing for use

1 Wash all detachable parts (see chapter 'Cleaning').
2 Pull the mains cord out of the cord storage compartment at the back of the appliance (Fig. 2).
3 Place the juice collector into the appliance (1). Place the pulp container by tilting it
forwards slightly (2). Insert the top end of the pulp container first and then push home
the bottom end (Fig. 3).
To empty the pulp container while you are juicing. Switch off the appliance and carefully remove
the pulp container.
Note: Reassemble the empty pulp container before you continue juicing.
4 Put the filter in the juice collector (1). Hold the lid over the filter and lower it into
position (2) (Fig. 4).
Make sure the filter is fitted securely onto the driving shaft ('click')
Always check the filter before use. If you detect any cracks or damage, do not use the appliance
and contact the nearest Philips service centre or take the appliance to your dealer.
5 Snap the two clamps onto the lid to lock it into place ('click') (1). Align the groove in the
pusher with the small protrusion on the inside of the feeding tube and slide the pusher into
the feeding tube (2) (Fig. 5).
Make sure the clamps are locked into position on either side of the lid.
6 Place the juice jug under the spout (Fig. 6).
Place the lid on the juice jug to avoid splattering or if you want to store the juice in the refrigerator.

using the appliance

The appliance will only function if all parts have been properly assembled and the lid has been
properly locked in place with the clamps.
1 Wash the fruit and/or vegetables and cut them into pieces that fit into the
feeding tube. (Fig. 7)
2 Make sure the juice jug has been placed under the spout.
3 Turn the control knob to setting 1 (low speed ) or 2 (normal speed) to switch on the
appliance. (Fig. 8)
- Speed 1 is especially suitable for soft fruits and vegetables such as watermelons, grapes,
tomatoes, cucumbers and raspberries.
- Speed 2 is suitable for all kinds of fruits and vegetables.
EnglisH
7