Installation; Appropriate Installation Location; Removing The Transportation Safety Assembly - Grundig GTA 38261G Benutzerhandbuch

4 Installation

Before the calling the nearest
Authorized Service for the
installation of the dryer, ensure that
electrical installation and water
drain is appropriate referring to the
user's manual.(See 4.4 Connecting
to the drain and 4.6 Electrical
connection) If they are not suitable,
contact a qualified electrician and
technician to make necessary
arrangements.
C
Preparation of the dryer's
location as well as the
electrical and waste water
installations is under
customer's responsibility.
A
Prior to installation,
visually check if the dryer
has any defects on it. If the
drier is damaged, do not
have it installed. Damaged
products cause risks for
your safety.
A
Let your dryer wait for 12
hours before starting to
use it.

4.1 Appropriate installation location

Install the dryer on a stable and level
surface.
Dryer is heavy. Do not move it by
yourself.
Operate your dryer in a well
ventilated, dust-free environment.
The gap between the dryer and the
surface should not be reduced by the
materials such as carpet, wood and
tape.
Do not cover the ventilation grills of
the dryer.
There must not be a lockable, sliding
or hinged door that may block the
opening of the loading door in the
place where your dryer is to be
installed.
Once the dryer is installed, it should
stay at the same place where its
connections have been made. When
installing the dryer, make sure
that its rear wall does not touch
anywhere (tap, socket, etc.).
Place the dryer at least 1 cm away
from the edges of other furniture.
Your dryer can be operated at
temperatures between +5°C and
+35°C. If the operating conditions
fall outside of this range, operation
of the dryer will be adversely
affected and it can get damaged.
B
Do not place the dryer
the power cable.
4.2 Removing the transportation
safety assembly
A
Remove the transportation
safety assembly before
using the dryer for the first
time.
Open the loading door.
There is a nylon bag inside the drum
that contains a piece of styrofoam.
Hold it from its section marked with
XX XX.
Pull the nylon towards yourself and
remove the transportation safety
assembly.
A
Check that no part of
the transportation safety
assembly remains inside
the drum.
DE
ENG
FR
GR
on
55