JVC VN-C625 Handbuch Seite 14

Preparation (Step 1 Connection/Installation)
1-1 Connecting Cables (Continued)
Cap (Upper)
E-14
3.
Lead the cable through the cover
Make a slit on the (rubber) cap that is attached
to the cover, followed by leading the cable
through. See diagram on the left on how to
make the slit.
4.
Connect the cable to this camera
Connect cables to the terminal on the ceiling
mount. Connection cables include alarm
signal cable, LAN cable, coaxial cable and that
for the Converter Unit.
1
Alarm signal cable (
Connect this cable to devices with alarm
input/output terminals.
2
LAN cable (
1
Connect this cable to a hub or PC.
3
Coaxial cable (
Connect this cable to NTSC monitors.
4
Converter Unit (
2
Connect this to a DC12V power supply.
3
5.
Attach the cover
4
Attach the cover to the ceiling mount by
following procedure of Step 2 in the reverse
order.
1
Attach the cover upon aligning the hole with
the safety wire mounting hole on the ceiling
mount, followed by turning it in the
clockwise direction.
2
Fasten the cover fastening screw.
☞
Page 15)
☞
Page 16)
☞
Page 17)
☞
Page 18)