Start-Up Of The Device/Introduction; Listening To The Radio; Aux In Socket; Cleaning And Maintenance - AEG MR 4144 Bedienungsanleitung

Start-up of the device/introduction

• Select a suitable location for the device, such as a dry,
flat, non-slip surface on which it is easy to operate the
machine.
• Ensure that the device is sufficiently ventilated!
Power supply (Batteries)
(not supplied)
1. Open the lid of the battery compartment (11) on the bot-
tom.
2. Insert 6 batteries of type AA/R6 1.5 V. Please ensure that
the polarity is correct (see the floor of the battery com-
partment)!
3. Then close the battery lid.
WARNING:
The batteries shall not be exposed to excessive heat such
as sunshine, fire or the like. Danger of explosion!
CAUTION:
• Batteries can leak battery acid. When not using the de-
vice for a longer period of time, remove the batteries.
• Different battery types or new and used batteries must
not be used together.
• Batteries are not to be disposed of together with
domestic wastes. Dispose of the used batteries at the
relevant collection bin or at your dealer' s .
Power supply (power adapter not included)
You may also operate the device via power adapter. When
using a power adapter, observe the following:
CAUTION:
• Make sure the grid voltage corresponds to the figures
on the rating plate.
• Only use 6 V / 600 mA power supply unit (
A different supply unit may damage the device.
NOTE:
Disconnect from mains power supply during longer periods
of non-use.
Headphone Socket
Please use headphones with a 3.5 mm stereo jack plug; these
should be inserted into the PHONES socket. The loudspeak-
er is switched off.
Volume
The desired volume can be sent using the VOLUME regula-
tor (1).
Switching On/Off
• Turn the device on by moving the function selector switch
(6) to the FM position. The ON indicator light goes on.
• The machine is switched off when the function selector
switch (6) is turned to the STANDBY position. The ON
indicator light turns off.

Listening to the Radio

1. Turn the function selector switch (6) to the FM position.
2. Fully extend the telescopic antenna. Adjust its position
accordingly for better reception.
3. Tune in the desired station with the station adjustment
knob TUNING (2).

AUX IN socket

To connect analogue replay devices. Through this socket you
can also listen to the sound of other playback devices such as
MP3 players, CD players etc. through the loudspeaker.
1. Turn the function selector switch (6) to FM.
2. Please connect the external device with a 3.5 mm stereo
jack plug to the AUX IN socket (8). The device switches
automatically to AUX IN operation. The radio sound is
switched off.
3. Through the loudspeaker you will hear the sound being
played back from the external device. With the VOLUME
control (1) you can change the volume.
4. For the remaining procedure please see the operating
instructions of the external sound source.
NOTE:
Adjust the volume of the external device to a comfortable
level.

Cleaning and Maintenance

CAUTION:
). • Do not use abrasive detergents! These can damage
the casing!
• Make sure that no humidity or water penetrates in the
device!
• Clean the device only with a soft, dry cloth.
• Any marks on the surface can be wiped off with a slightly
damp cloth without any additives.
• Dry well with a dry, soft cloth!

Technical Data

Model: ..................................................................................MR 4144
Power supply: ...........................................DC 6 V, 0.6 A,
Battery operation: ..................................................6 x 1.5 V AA/R6
Power consumption:...................................................................4 W
Protection class: ...............................................................................III
Net weight: ............................................................approx. 0.518 kg
Radio section:
Frequency ranges:.......................................... FM 87.5 ~ 108 MHz
English
21