Closing The Door; Technical Data; Installation - Electrolux A71108TSW0 Benutzerinformation

Problem
Green indicator flashing

Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "Installation".
3. If necessary, replace the defective door gaskets. Contact the Service Center.

TECHNICAL DATA

Dimension
Rising Time
The technical information are situated in the rating plate on the internal left side of the
appliance and in the energy label.

INSTALLATION

WARNING!
Read the "Safety Information" carefully for your safety and correct operation of the appli-
ance before installing the appliance.
Positioning
This appliance can be installed in a dry, well ventilated indoor (garage or cellar) also, but for
optimum performance install this appliance at a location where the ambient temperature
corresponds to the climate class indicated on the rating plate of the appliance:
Climate class
SN
N
ST
T
Possible cause
There is no voltage in the mains
socket (try to connect another
appliance into it)
The appliance is not switched on Switch on the appliance
Temperature Regulator is not on Check the Temperature Regulator
Temperature sensor problem
Height
Width
Depth
+10°C to + 32°C
+16°C to + 32°C
+16°C to + 38°C
+16°C to + 43°C
Call an electrician
Call the service personnel
850 mm
595 mm
635 mm
24 h
Ambient temperature
31
Technical data
Solution