Setting The Signal Type; Setting The Volume - Silvercrest IAN 102932 Wireless Doorbell Bedienungsanleitung

The signal indicator
cate the synchronisation is successful.
NOTE: The synchronisation mode can only last for approx. 2 minute. If
you cannot synchronise your transmitter and receiver, please enter syn-
chronising mode again.
NOTE: After the transmitter and receiver have been successfully
synchronised, wait for approx. 2 minutes until a visual signal appears.
The signal display
transmitter and receiver are synchronised.

Setting the signal type

The receiver can indicate the reception of a door signal either optically
or acoustically or both optically and acoustically.
Using the signal type selector button
is to be indicated optically or acoustically or both optically and
acoustically.

Setting the volume

Press the volume button
are a total of 4 possible volume settings: very loud, loud, medium, soft.
on the receiver will then blink. This is to indi-
1
on the receiver goes out after 2 minutes, the
1
until the desired volume is reached. There
3
Operation
, select whether the signal
5
GB/IE 15