Preparing For Use; Inserting / Replacing The Batteries - Silvercrest HG01910 - IAN 280620 Montageanleitung Und Bedienungsanleitung

Preparing for use

Preparing for use
For first time use, please remove the protective foil from the name
plate of the transmitter.
12

Inserting / replacing the batteries

Insert the batteries to provide power to the device before preparing
it for use.
CAUTION! Use the above-indicated battery types only. Failure to
observe this advice may result in damage to the product.
Receiver:
Remove the battery compartment cover
Remove the used batteries, if present.
Insert 2 batteries (1.5 V
Note: Ensure correct polarity. This is indicated in the battery
compartment
Close the battery compartment
Transmitter:
Remove the holder
Remove the used batteries, if present.
Insert a battery (3 V
The side marked "+" must face upwards.
Fasten the holder
26 GB/IE
(direct current), type AA).
.
10
from the back of the transmitter.
15
(direct current), type CR 2032).
of the receiver back on to the back of the device.
15
from the back of the device.
9
.
10