Siemens VZ103WD Gebrauchsanweisung Seite 7

Innenteil 134 601 A
en
Fold out picture pages.
Setting up
1
Figure
Connect the wiping tool to the suction
pipe.
2
Figure
Press the release button.
3
Figure
Remove the casing from the cloth hold-
er and place it to one side.
4
Figure
Lay a new cleaning cloth on the floor
and position the cloth holder in the cen-
tre of the cloth.
Secure the cleaning cloth at the clamp-
ing points.
5
Figure
Refit the casing and click it into the
cloth holder.
!
Do not attach the cloth holder by hand
=> there is a risk of injury.
6
Figure
Remove the cleaning cloth from the
nozzle after use and dispose of it with
the household rubbish.
26.02.2009 13:11 Uhr Seite 5
Care
Switch off the vacuum cleaner before you
start any work on it.
7
Figure
Pull the wiping tool from the suction
pipe. Dirty bristles on the tool may be
cleaned using the crevice nozzle.
!
Please note
Clean the tool casing and cloth holder
using a moist cloth if necessary.
Accessories
You can use commercially available wet
cleaning cloths for the tool.
Subject to technical changes.
5