Troubleshooting - Klarstein 10026970 Bedienungsanleitung

Humidity sensor
In the movement process, this device is used for induction
clothing humidity, it means that it must be carried on cleaning.
Major cause of clean is must scour out the calcium oxide boiler
which on the sensor surface up. Clean the sensor in the tumbler.
Lamp replace
1. Open the door,put your hand into the drum of a clothes dryer, use screw driver 1. Open the door,put your hand into the drum of a clothes dryer, use screw driver
unscrew two pieces of screw and take out lamp screen.
2. Take out the bulb by turning counterclockwise. Be
carefully.
3. According to installs new bulb with its reverse direction's
process.
4. Catch the lamp screen by hand and hard push
counterclockwise, until the bulb has loosened.

TROUBLESHOOTING

Certain problems are due to lack of simple maintenance or oversights, which can be
solved easily without calling out an engineer. Before conacting your local Service
Centre, please carry out the checks listed underneath.
During machine operation it is possible that the Start/Pause pilot light fl ashes to indicate
that the machine is not working. Once the problem has been eliminated, press the Start/
Pause button to restart the programme. If after all checks, the problem persists, contact
your local Service Center.
Malfunction Possible Cause
Dryer does not Main plug is not plugged
work in.
Loading door is open.
Start button hasn't been
pressed.
Solution
Plug in all main sockets.
Close loading door.
Press the Start button again.
EN
35