Werbung
Verfügbare Sprachen
Verfügbare Sprachen
English-2
7. After getting the Install Recommendation, you must shut down your
8. Remove the cover from your computer.
9. Prepare the drive bay:
10. Attach any required rails or mounting hardware, if any, to your CD-
11. Write the CD-Writer Plus' serial number in the space below. The serial
12. Read the Install Recommendation to learn if the jumper on the CD-
Installing CD-Writer Plus and Software
computer when prompted, and turn off your computer, monitor, and
connected devices. Unplug the power cords from power outlets.
If you are installing the drive into an empty drive bay, remove the
cover plate from a larger half-height drive bay (approx. 6" x 1.75"/15cm x
4.5 cm)
.
If you are replacing an existing CD-ROM drive, remove the drive. Take
note of where the cables are attached and lay them aside to reconnect to
the CD-Writer Plus. You will not need the data cable that came with your
CD-Writer Plus. Remove any mounting rails or hardware from the drive
and set them aside.
Writer Plus drive.
number is on the main label on the top of the drive.
Serial
number:
Writer Plus should be set as Master or Slave.
Werbung
