Westfalia ASSG 18 Originalbetriebsanleitung Seite 21

 Apply the machine to the workpiece only when switched on.
Otherwise there is danger of kickback when the cutting tool
jams in the workpiece.
 When sawing, the footplate must always faces against the
workpiece. The saw blade can become wedged and lead to
loss of control over the machine.
 When the cut is completed, switch off the machine and then
pull the saw blade out of the cut only after it has come to a
standstill. This way you can avoid kickback and can place
down the machine securely.
 Use only sharp, flawless saw blades. Bent or blunt saw blades
can break or cause kickback.
 Do not slow down the saw blade by applying side pressure
after switching off. The saw blade can be damaged, break or
cause kickback.
 Do not cut or saw where there might be hidden electric wires,
gas or water pipes.
 Use suitable detectors to determine if utility lines are hidden in
the work area or call the local utility company for assistance.
Contact with electric lines can lead to fire and electric shock.
Damaging a gas line can lead to explosion. Penetrating a
water line causes property damage or may cause an electric
shock.
 Ensure that the lighting is adequate.
 Ensure that the reciprocating saw blade is securely fixed in the
holder. Insecure accessories can be ejected from the machine
causing a hazard.
 Do not exert pressure on to the tool. To do so would shorten
its service life.
 If you are interrupted when operating a reciprocating saw,
complete the process and switch off before looking up.
 Where possible, use clamps or a vice to hold your work.
 Examine the tool holder regularly for signs of wear or damage.
Have damaged parts repaired by a qualified service centre.
Safety Notes
17