Yamaha mLAN8P Bedienungsanleitung Seite 22

Connecting I/O signals between mLAN devices
4-1. In the "From:" field, use the [+1/ENTER] and [–1/EXIT] buttons or the [VALUE] dial to select
the desired device to connect to Channel 1 on the mLAN8P. The Device/Nickname of the
selected device flashes.
NOTE
4-2. If multiple units of the same model are connected (as in this example), both "Device" fields
display "YAMAHA/A5000," but does not indicate which is A or B. In this case, press the mode
button to display the Nickname of the selected device.
NOTE
5. Select "Liverpool (or A5000/Liverpool)" and press the [PAGE
plays the Audio In Plug page.
6. In the "From:" field, use the [+1/ENTER] and [–1/EXIT] buttons or the [VALUE] dial to select
the desired mLAN plug to connect to Channel 1 on the mLAN8P. In this example, select
"Channel 3 (AS3)."
NOTE
22
If you are setting the output destination, the "To:" field appears instead of the
"From:" field.
First, you need to specify a Nickname for each device (page 34).
A temporary Nickname has been set at the factory. The last three digits of
the alphanumeric number (hexadecimal) indicate the device's unique ID
number.
If you are setting the output destination, the "To:" field appears instead of the
"From:" field.
] button. The mLAN8P dis-