Hama 00137473 Bedienungsanleitung Seite 6

Note
• If pairing was successful, the status LED (3) will be lit blue.
• It may be necessary to make settings on your terminal device to enable automatic connection
to the paired adapter.
Note – Connection impaired
After the devices have been paired once, the connection is then established automatically. If the
Bluetooth connection is not established automatically, check the following:
®
• Check the Bluetooth
• If not, repeat the steps listed in 5.2 Bluetooth
• Check whether obstacles are impairing the range. If so, move the devices closer together.
• The performance can also be affected by a weak battery.
5.5. Pairing in transmitter (TX) mode with two devices at the same time
• Switch on the adapter and your two Bluetooth
as described in 5.2 Bluetooth
• The adapter automatically names the two terminal devices A and B, and establishes a connection.
5.6. Deleting the pairing list
• Switch off the adapter in the current mode (TX or RX). After approximately 3 seconds, move the
switch (1) to the other mode and switch the adapter on again; this will delete all paired devices
from the list.
5.7. Battery capacity
• The status LED (3) begins flashing red when the battery charge is low.
• Charge the adapter as described in 4. Getting started.
6. Care and Maintenance
Only clean this product with a slightly damp, lint-free cloth and do not use aggressive cleaning
agents.
7. Warranty Disclaimer
Hama GmbH & Co KG assumes no liability and provides no warranty for damage resulting from
improper installation/mounting, improper use of the product or from failure to observe the operating
instructions and/or safety notes.
8. Service and Support
Please contact Hama Product Consulting if you have any questions about this product.
Hotline: +49 9091 502-115 (German/English)
Further support information can be found here:
www.hama.com
settings of your terminal device to see whether BTI-020V is connected.
®
pairing.
®
pairing.
®
-capable audio devices (BT headphones/speaker)
®
5