Operating - Westfalia Laser2000 Bedienungsanleitung

Using the Extension Hose (9)
Connect the bayonet joint with the housing. Insert the
accessory (upholstery nozzle or long nozzle) into the
other side of the extension hose. Turn the accessory to
the right until the stop pin on the extension hose fits into
the opening of the accessory.
To remove the accessory, first press the red stop pin
down and turn the accessory to the left. Pull the acces-
sory straight out of the extension hose.

Operating

1. Plug in the power plug to an earthed wall socket. The indicator light (3) turns
on. Allow the water to heat up for at least 3 minutes and to form sufficient
steam. If the temperature has been reached, the indicator light turns off.
2. When using the hand steam cleaner, carry the appliance by the handle (5)
only and hold it horizontally. Shortly press the steam button (6) once. When
steam is formed, the appliance is ready for use. If you wish continuous steam,
hold the steam button pressed. We recommend using the hand steam cleaner
with short time intervals so in the meantime, the appliance can form new
pressure.
3. Before using the appliance for cleaning, we recommend testing the hand
steam cleaner on a hidden place.
Do not direct hot steam towards sensitive surfaces for long time but evenly
move the hand steam cleaner over the surface to be cleaned. When using the
upholstery nozzle with the cotton towel, do not let the hand steam cleaner
stand on a place for a long time. Do not direct the hand steam cleaner towards
a cold or frosted window. Due to the quick temperature change the window
might break.
Do not tilt the hand steam cleaner more than 45° because not only steam will
escape but also boiling water.
4. After finishing work resp. if no steam is formed, pull the power cord from the
wall socket.
Using
12