Herunterladen Inhalt Inhalt Diese Seite drucken

Technical Data; Safety Instructions - Klarstein 10028293 Gebrauchsanweisung

Vorschau ausblenden Andere Handbücher für 10028293:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
Dear Customer,
Congratulations on purchasing this Klarstein equipment. Please read this manual carefully and take
care of the following hints on installation and use to avoid technical damages. Any failure caused by
ignoring the mentioned items and cautions mentioned in the operation and installation instructions
are not covered by our warranty and any liability.
Item number
Power supply
Power consumtion
• Never attach the fan to a power point, but to the ceiling itself.
• The minimum distance between the blades of the fan and the fl oor must be 2.3m. The minimum
carrying capacity of the hook from which the fan is hung must be 100kg.
• Make sure to install all poles disconnection switch having a contact separation of at least 3mm
between poles in the supply wiring to the ceiling fan.
• Install only bulbs of the type intended for your fan.
• Switch off the power before connecting or repairing the fan.
• The fan must be properly grounded to avoid the risk of electric shocks.
• Never mount the fan in a moist or wet room.
• Be careful when working near the rotating blades.
• Always have your fan installed by someone who is knowledgeable about electrical wiring.
• This appliance is not intended for use by persons (including children) with reduced physical. Sen-
sory or mental capabilities, or lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a person responsible for their safety.
Page 1 of 3 Children should be supervised to ensure that they do not play with the appliance.
1. Secure the mounting plate
to a ceiling joist with two
screws,
spring
and fl at washers provided.
Ensure the support for the
mounting plate must be
capable of safely and se-
curely holding the moving
weight of the fan.
5

Technical Data

Safety Instructions

Mounting
2. Insert the remote con-
trol receiver between the
washers
bracket and the ball joint,
and the sensor as shown.
10028293
220-240 V ~ 50-60 Hz
55 W
3. Hang the fan onto the
bracket hook by using one
of the holes at the top of
the upper canopy.

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis