Changing The Bulb - Bosch HBC 24D652 Gebrauchsanweisung

Problem
The display panel is blank.
The time is not correct.
The oven lamp is not working.
Steam or water escapes from
the air vent during cooking.
There is a plop" noise during
cooking.
The oven cannot be set.

Changing the bulb

Possible cause
Power cut
The electronics are
defective.
Power cut
The bulb is faulty.
Cold/warm effect of frozen
food, caused by the steam.
The childproof lock is
active. ( p symbol in the
display field)
Repairs may only be carried out by fully trained
after sales service technicians.
Incorrect repairs may result in serious injury to the
user.
The bulb must be replaced if it fails. You can do this
yourself. Heat resistant replacement bulbs can be
obtained from a specialist store.
Technical data about bulbs:
15 25 watts, 220/240 V, 300 ºC, lamp socket E14.
Method:
1.
Switch off the fuse in the fuse box or unplug the
oven at the mains.
2.
Twist the cover anti clockwise to remove.
3.
Unscrew the bulb anti clockwise.
4.
Replace the bulb with one of the same type and
wattage.
5.
Screw the bulb and the cover back on. Ensure that
the seals are in the correct position.
6.
Reconnect the oven and reset the time.
Comments/remedy
Check the power supply.
Call after sales service.
Reset the time.
Change the bulb. See the Changing
the bulb" section.
This is normal.
This is normal.
Deactivate the childproof lock.
45