Commissioning; Initial Operation; Setting The Transmission Channel On The Camera - Conrad 75 17 85 Bedienungsanleitung

The video connecting plug (yellow) may only be connected to a video cinch input.
If you are not sure about the correct connection procedure, contact our technical
support or another specialist.
To extend the audio and video signal, only use suitably shielded
cinch cables. The use of other cables might cause interference.
Keep the length of the cable as short as possible.

6. Initial Operation

• Insert the plug-in mains supply units of the wireless camera system into the mains
sockets.
• Set the desired transmission channel on the camera (see Chapter "6.1. Setting the
Transmission Channel on the Camera").
• Switch on the display device (TV or monitor) and select the corresponding channel in
order to facilitate the display.
7. Operation
7.1 Camera Channel Set-Up
On the back of the camera, you will find a sliding switch. The desired transmission
channel can be set by means of the sliding switch. The switch positions are labeled,
so as to indicate the transmission channels.
28
Channel 1
Channel 2