Installation - Conrad 55 25 17 Bedienungsanleitung

O P E R A T I N G I N S T R U C T I O N S
Wireless chime
Item no. 55 25 17
Intended use
Pressing the provided wireless doorbell button triggers an audio signal at the wireless chime (32 different
pre-programmed audio signals available).
The wireless bell push is powered by a 12 V battery (type 23A; included).
The wireless chime can be powered either by 3 batteries of type AA/Mignon or by a mains power cord (each
available as accessory).
The wireless bell push is protected according to IP44 and can be used in protected outdoor areas (e.g. under
eaves). The wireless chime may be used only in dry areas indoors.
Always observe the safety instructions included in these operating instructions. Read the operating manual
carefully; keep it in a safe place or pass it on to others using the product.
Any use, other than the one described above, may damage the product. Moreover, this involves hazards
such as e.g. short circuit, fi re, electric shock, etc. The product may not be modifi ed or rebuilt!
This product complies with the applicable national and European requirements. All names of companies and
products are the trademarks of the respective owner. All rights reserved.
Explanation of Symbols, Inscriptions
This symbol indicates a health hazard, e.g. electric shock.
The exclamation mark indicates specifi c risks associated with handling, function and use.
☞
The "Hand" symbol indicates special tips and operating information.
Package Contents
• Wireless chime
• Wireless doorbell button
• Double-sided adhesive pad for the wireless bell push
• 12 V battery Type 23A
• Operating Instructions
Safety Instructions
The warranty will be void in the event of damage caused by failure to observe these safety
instructions! We do not assume any liability for any consequential damage!
Nor do we assume any liability for material and personal damage caused by improper use
or non-compliance with the safety instructions! The warranty will be void in such cases!
• The unauthorised conversion and/or modifi cation of the product is not permitted for safety and
approval reasons (CE).
Maintenance or repair works must always be carried out by qualifi ed experts who are familiar
with the hazards involved and with the relevant regulations.
• The product is not a toy and must be kept out of the reach of children. It contains small items
and batteries.
• The wireless bell push is protected according to IP44 and can be used in protected outdoor
areas (e.g. under eaves). The wireless chime may be used only in dry, enclosed areas
indoors.
• Do not operate the device in environments where there are high levels of dust, fl ammable
gases, vapours or solvents. There is a danger of fi re and explosion!
• Do not carelessly leave the packaging material lying around since this may become a danger-
ous toy for children.
• Handle the product with care, it can be damaged by impacts, blows, or accidental drops, even
from a low height.
• If you have any questions that are not answered in this manual, please contact our technical
service or another specialist.
General information on batteries/rechargeable batteries
www.conrad.com
• Batteries/rechargeable batteries must be kept out of the reach of children.
• Do not leave batteries/rechargeable batteries lying around; they could be swallowed by children or pets. If
swallowed, consult a doctor immediately.
Version 04/13
• Leaking or damaged batteries/rechargeable batteries can cause acid burns if they come in contact with the
skin, therefore, use suitable protective gloves.
• Batteries/rechargeable batteries must not be short-circuited, opened or thrown into a fi re. There is a risk of
explosion!
• Do not recharge normal, non-rechargeable batteries, risk of explosion! Only charge rechargeable batteries
that are intended for this purpose; use a suitable battery charger.
• Never mix standard batteries with rechargeable batteries, use either standard batteries or rechargeable
batteries.
• Do not mix batteries/rechargeable batteries with different charge levels (e.g. full and half-full batteries/
rechargeable batteries).
• Always replace the complete set of batteries/rechargeable batteries.
• Check that the polarity is correct when inserting the batteries/rechargeable batteries (pay attention to
plus/+ and minus/-).
• If you wish to use rechargeable batteries in the wireless chime, please note that the operating time will
decrease due to lower output voltage (batteries = 1.5 V, rechargeable batteries = 1.2 V). Therefore, we
recommend that you use high-quality alkaline batteries to ensure long-lasting and reliable operation.
Controls
1
2
3
4
5
6
7
8
9
10 "PLAY" button (this is activated with the bell push (7))
11 "SELECT" button for selection of one of the 32 audio signals
12 Battery compartment for a 12 V battery of type 23A

Installation

☞
a) Wireless bell push
The wireless bell push can be attached to a clean, smooth, dust-free surface with the provided tape on the
back of the bell push. Alternatively, the bell push can be secured with suitable screws/dowels through two
openings.
For this purpose, open the housing of the bell push (lever off the back of the housing with a fl at screwdriver
or your fi ngernail). Then secure the back of the housing with two screws and dowels if needed, to the desired
surface. Be careful not to damage the circuit board when you do this!
Before you close the housing again, insert the 12 V battery and, if necessary, select one of the 32 audio
signals.
b) Wireless chime
The wireless chime can be hung from a nail, hook or screw, using an opening on the back.
Loudspeaker
Status LED
8
Opening for wall-mounting
Socket for connection of an external mains power cable (5 V/DC, 1 A, round plug with exterior Ø 5.5 mm,
interior Ø 2.1 mm, inner contact is positive/+)
Button to register a wireless bell push
Battery compartment lid (battery compartment for 3*AA size batteries)
Bell push (with red function LED)
Indentation on the underside, for opening the housing
Red function LED
The range between the wireless bell push and the wireless chime is dependent on the environ-
mental conditions. As a rule, when operated in a single-family home, faultless operation should
be possible. We recommend that you check the function of the product before a fi nal installation.
Make certain when drilling and tightening the screws that no cables or pipes are damaged.
3
4
1
5
2
6
9
7 10
11
12