Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
t
t
He
raNsIeNt
What ? :
Record occasional events and log slow changing processes automatically, e.g. battery charge cycles,
temperature changes,... or track intermittent faults in electronic circuits. Automatic data storage allows over
one year of continuous recording !
2
How ? :
• Connect the scope input to the circuit under test. (or the internal generator at a low frequency)
• Select the appropriate channel and volts/div (or volt range) setting (1).
• Select the appropriate time/division setting (3).
• Press RUN (2) to start recording.
* Press RUN again, to stop the measurement, or use the "Single" button to make a single screen
measurement.
For continuous recording with auto-save to your HD, select 'AutoSave Data' from the 'File'-menu.
Notes:
• During recording the screen can differ from the actual measurement.
10
• Events happening between two sample acquisitions will be missed if a too slow time/div is set
r
m
ecorder
odule
3
1
:
t
b
He
ode Plotter module
What ? :
Due to the unique scope and generator combination, an automated Bode plot function is possible.
This results in a powerful tool for amplifier or filter measurements.
4
How ? :
• Enable the Circuit Analyser window (1)
• Connect the scope CH1 input to the output of the circuit or unit under test.
• Connect the generator output to the input of the circuit or unit.
• Adjust the generator output (2) to a suitable level.
• Adjust the setting of the Bode plot module like Volt range (3) Volt scale,
frequency start and stop range (4)...
• Press 'Start' (5) and observe the screen and measurement window (6)
• If the signal is out of the screen range, adjust the Voltage range or generator output level.
:
1
5
3
6
2
11
Werbung
Inhaltsverzeichnis
