Westfalia 108514 Bedienungsanleitung Seite 20

Installing Tabletop
(Fig. 9 – 12)
1. Install tabletop (A) to height adjustment post using
three M8 x 20 mm hex head screws (N2) and 8
mm lock nuts (M2).
Make sure the pre-mounted pull handle at the
tabletop faces in the direction of the casters.
2. Repeat this step on the other side and tighten all
screws.
3. Locate the bag containing steel clamp levers and
washers (E). Place four small washers on the
shanks of the four small steel clamp levers.
4. Attach the steel guide rails (C1) and (C2) to the
table using the steel clamp levers (E).
5. Tighten the nuts at the pull handle (1).
Assembly Instruction
and Steel Guide
15
Rails