Operation - Kärcher EB 30/1 Handbuch

Installing the telescopic handle and
the handle and adjusting the height
see Figure 2
The telescopic strut consists of 3 parts.
While assembling it, make sure that the
parts lock into each other.
 Insert the handle on the longer strut
with turning handle.
 Insert together the longer and shorter
struts; while assembling it, press the
locking button.
 Insert the entire strut with the locking
button into the joint on the appliance.
 Loosen the handle and pull out the strut
to the desired working height; turn the
handle to the correct position and tight-
en using the turning handle.
Charge the battery
see Figure 3
The battery is not charged at the time of de-
livery. Charge it before commissioning the
appliance and then as and when required.
Note: The battery can be charged only
when it is removed out of the appliance.
 Connect the battery to the charger us-
ing the charging cable or rather insert
the battery in the charger.
 Insert the charger delivered with the ap-
pliance into a proper socket.
The charger display glows red. The battery
is being charged.
Charging time for empty battery
Charger NiCd
6.654-
186.0
BC 1/0.1 12 h
BC 1/0.45 --
BC 1/1.8 50 min
Note: If the charging time is exceeded, the
charger shifts to retention charging. The
charger display continues to glow red.
Li-Ion Li-Ion
6.654- 6.654-
257.0 273.0
-- --
3 h 6 h
45 min 90 min
Insert the battery
see Figure 4
 Insert the battery into the intake and
lock it.
Lock/unlock telescope strut on the
see Figure 5
The Cardan joint can be locked to clean
high-fiber carpets to prevent the telescope
strut from moving from side to side.
– Lock/unlock telescope strut on the side:
 Activate the lock, then move it down
and lock it in.
– Unlock telescopic strut:
 Activate the lock, then move it up and
lock it in.
Starting the work
see Figure 6
 Switch on the appliance; press the on/
off foot switch to do so.
 Move the appliance forward and back-
ward to clean it.
 Use the right side (battery side) to clean
the appliance close to the edges.
Interrupting the work
see Figure 7
 Switch off the appliance; press the on/
off foot switch to do so.
 To ensure that the telescopic strut
stands safely during breaks in opera-
tion, hold it vertically; there is a stopper
that holds it in position.
Finishing your work
 Switch off the appliance when finished.
 Empty dirt container after each clean-
ing.
 Press the unlocking button of the bat-
tery and remove the battery.
 Charge the battery.
– 3
EN

Operation

side
11