Before Starting The Equipment - EINHELL 42.578.43 Originalbetriebsanleitung

Anleitung_BT_EN_30_E_SPK1:_
GB
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Total vibration values (vector sum of three directions)
determined in accordance with EN 50144.
Vibration emission value a = 5,796 m/s 2
h
K uncertainty = 1,5 m/s 2
Important!
The vibration value changes according to the area of
application of the electric tool and may exceed the
specified value in exceptional circumstances.
Keep the noise emissions and vibrations to a
minimum.
Only use appliances which are in perfect working
order.
Service and clean the appliance regularly.
Adapt your working style to suit the appliance.
Do not overload the appliance.
Have the appliance serviced whenever
necessary.
Switch the appliance off when it is not in use.
Wear protective gloves.

5. Before starting the equipment

Before you connect the equipment to the mains
supply make sure that the data on the rating plate
are identical to the mains data.
Always pull the power plug before making
adjustments to the equipment.
Inserting the staples (Fig. 2-4)
Switch the tool off and pull the power plug.
Press the magazine slide together using your
thumb and index finger (Fig. 2).
Pull the magazine slide toward the rear of the
electric stapler (Fig. 3) and out.
Fill the magazine with staples or nails (Fig. 4).
Then slide the magazine slide back in until it stops
and snaps noticeably into place.
Important!
It must be possible to move the magazine slide
without applying much force. Watch out for jammed
staples and nails.
10
11.09.2009 12:42 Uhr Seite 10
Setting the stapling force (Fig. 1)
You can pre-select the stapling force of the electric
stapler to suit the length of the staples or nails used
and the strength of the material. To do so, set the
stapling force control (3) to the desired force. The
ideal stapling force is best determined by carrying out
a trial on a test piece.
6. Starting up
Operation (Fig. 1/5/6)
Before starting your work, always check the filling
level indicator (6) to see if the magazine (5)
contains staples or nails and is properly closed with
the magazine slide (4).
Switching on the electric stapler
Switch on the electric stapler using the On/Off switch
(2) (switch position I) directly before starting work.
The tool is now ready for operation. If the electric
stapler is no longer in operation – even for short
periods – switch off the tool with the On/Off switch
(switch position 0) to prevent unintentional operation.
Triggering shots
The built-in trigger locks prevent the electric stapler
from being triggered accidentally.
Triggering is only possible as follows:
Press the head of the electric stapler against the
material and operate the trigger (1).
Inserting staples
Fill the staples into the magazine as shown in Fig. 5.
Inserting nails
Fill the nails into the magazine as shown in Fig. 6.
Stapling textiles, materials, leather, etc.
Press the head of the electric stapler against the
object where you want to staple and operate the
trigger.
Stapling wood strips
Use only nails to staple wood strips. Do not press
the electric stapler too firmly against the wood strip
or you might damage the surface.
Filling level indicator (Fig. 1)
The filling level indicator (6) shows you if there are still
enough staples or nails in the magazine (5). If
necessary, refill the magazine (5) as described
above. Avoid operating the trigger (1) if there are no
staples or nails in the magazine (5).