General Safety Instructions - Bosch B25L Gebrauchsanleitung

Thank you for buying the sensixx B25L steam station,
the new steam-ironing system from Bosch.
Carefully read through the operating instructions
for the appliance and safeguard them for future
reference.
Introduction
These instructions for use contain valuable information
about the unique features of this system and some hints
to make ironing easier for you.
This powerful system produces non-stop steam for an
ideal ironing performance. It has a large detachable water
tank that can be refilled at any time without switching off
the system.
We hope that you enjoy ironing with this steam station.
Important
Open out the first page of the booklet, this will help you to
understand how the appliance works.
This appliance complies with international safety
standards.
This appliance has been designed exclusively for
domestic use and must not be used for industrial
purposes.
This appliance must only be used only for the purposes
for which it was designed, i.e. as an iron. Any other use
will be considered improper and consequently dangerous.
The manufacturer will not be held responsible for any
damage arising from misuse or improper use.

General safety instructions

• This appliance is to be connected and used in
accordance with the information stated on its
characteristics plate.
• This appliance must be connected to an earthed
socket. If it is absolutely necessary to use an extension
cable, make sure that it is suitable for 16A and has a
socket with an earth connection.
• The iron should not be used if it has been dropped,
if there are visible signs of damage or if it is leaking
water. It must be checked by an authorized Technical
Service Centre before it can be used again.
• If the safety fuse fitted in the appliance blows, the
appliance will be rendered inoperative. To restore
normal operation the appliance will have to be taken
to an authorised Technical Service Centre.
• In order to avoid that, under unfavourable mains
conditions, phenomena like transient voltage drops or
lighting fluctuations can happen, it is recommended
that the iron is connected to a power supply system
with a maximum impedance of 0.27 Ω . If necessary,
the user can ask the public power supply company for
the system impedance at the interface point.
• This appliance is not intended to be used by persons
(including children) with reduced physical, sensory
or mental capacities, or lack of experience and
knowledge, unless they have been given supervision
or instruction concerning the use of the appliance by a
person responsible for their safety.
• Children should be supervised to ensure that they do
not play with the appliance.
• Remove the plug from the socket before filling
the appliance with water or before pouring out the
remaining water after use.
• The appliance must never be placed directly under the
tap to fill the water tank.
• The appliance must be used and placed on a stable
surface.
• When placed on its stand, make sure that the surface
on which the stand is placed is stable.
• The iron must not be left unattended while it is
connected to the supply mains.
• Unplug the appliance from the mains supply after
each use, or if a fault is suspected.
• The electrical plug must not be removed from the
socket by pulling the cable.
• Never immerse the iron or steam tank in water or any
other fluid.
• Do not leave the appliance exposed to weather
conditions (rain, sun, frost, etc.).
• With the aim of avoiding dangerous situations, any
work or repair that the appliance may need, e.g.
replacing a faulty mains cable, must only be carried out
by qualified personnel from an Authorised Technical
Service Centre.
Important :
• This appliance reaches high temperatures and
produces steam during use, this could cause scalds
or burns in case of improper use.
• The steam hose, base station and in particular the iron
can get hot when used.
• Never aim the steam at people or animals.
• Do not allow the power cable to come into contact with
the soleplate when it is hot.
• Be aware that the system can keep on steaming a
short additional time after releasing the steam trigger.
This is a normal function.
Description
1. Removable water tank
2. Removable iron pad
3. Variable steam control *
4. "Energy saving" button
5. Steam hose
6. Illuminated main power 0/I button
7. "Steam ready" / "Auto shut-off" pilot light
8. "Water empty" / "Clean warning" pilot light
9. Housing with internal steam generator
10. Mains plug
en
11