Hama 00136106 Bedienungsanleitung Seite 2

G Operating instruction
Thank you for choosing a Hama product.
Take your time and read the following instructions and
information completely. Please keep these instructions
in a safe place for future reference. If you sell the device,
please pass these operating instructions on to the new
owner.
1. Explanation of Warning Symbols and Notes
Warning
This symbol is used to indicate safety instructions or
to draw your attention to specific hazards and risks.
Note
This symbol is used to indicate additional information
or important notes.
2. Package Contents
• Universal Power Pack, 5200 mAh
• Micro-USB charging/connecting cable
• These operating instructions
3. Safety Notes
• The product is intended for private, non-commercial
use only.
• Protect the product from dirt, moisture and
overheating, and only use it in a dry environment.
• Keep this product, as all electrical products, out of the
reach of children!
• Do not drop the product and do not expose it to any
major shocks.
• Do not operate the product outside the power limits
given in the specifications.
• Do not open the device or continue to operate it if it
becomes damaged.
• Dispose of packaging material immediately according
to locally applicable regulations.
• Since the battery is integrated and cannot be removed,
you will need to dispose of the
as a whole. Do this in compliance with the legal
requirements.
2
• Do not modify the product in any way. Doing so voids
the warranty.
4. Operation
4.1 Charging the Power Pack
• Begin charging the Power Pack by connecting the
Micro-USB charging/connecting cable included to the
Micro-USB input on the Power Pack (IN) as well as the
USB port on a PC/notebook.
• Alternatively, you can charge the Power Pack using
a suitable USB charger. Please refer to the operating
instructions for the USB charger used.
• Charging begins and ends automatically.
• Charge the Power Pack fully before using it for the
first time.
Note – Capacity
• The capacity is always shown when the Power Pack
is charging.
• Each status LED corresponds to 25% of the
capacity. When an LED is permanently illuminated,
this indicates that this capacity level has already
been reached. The Power Pack is charged to at
least 75% if three LEDs are illuminated, and the
fourth is flashing.
• If all four status LEDs light up, the full capacity is
available.
• Press the button on the top of the Power Pack to
switch it on and to check its current capacity.
• To switch the Power Pack off, press and hold the
button on the top until the status LEDs go out.
product