Dell PowerVault 136T LTO/SDLT Handbuch Seite 6

1-4 Installing VersaRails
bottom of
VersaRail

     
3. Position the VersaRail's mounting flange against the inner side of the rack's front
vertical rail so that the bottom of the VersaRail is aligned with the 0.125-inch
spacing on the rack's front vertical rail (see Figure 1-2).
NOTE: Ensure that you use the mounting holes, as shown in Figure 1-2, to secure the
front of the VersaRails to the rack. The second mounting hole from the bottom of the
VersaRail is used to secure your system to the rack.
4. Secure the front of the VersaRail to the rack using three Phillips-head screws and
three conical washers (see Figure 1-3).
second hole
from the
0.125-inch rail
spacing
0.125-inch rail
spacing