Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
20
Setup and operation
•
In standby mode, the on/off button for ice cube preparation will flash every
second.
•
In standby mode, press ICE MAKING (on/off) button once to enter ice cube
preparation mode, then press ICE MAKING (on/off) button again to return to
standby mode.
•
In standby mode, press the CLEANING button once to activate cleaning mode.
Then press and hold the CLEANING button for 3 seconds to return to standby
or ice making mode.
Ice cube making mode
Note: In ice making mode, ICE MAKING (on/off) buttons and the ice cube
preparation indicator light are always on.
•
From ice making mode, you cannot go directly to cleaning mode by pressing
the CLEANING button.
•
In ice making mode, press the ICE MAKING (on/off) button once to return to
standby mode.
•
Then press the CLEANING button to activate cleaning mode.
Cleaning mode
In cleaning mode, the water flows from the upper water tank to the evaporator
and back to the lower water tank (water circulation). After the water pump runs for
7 minutes, the cleaning mode will end and the standby mode will be activated.
•
In cleaning mode, press and hold the CLEAN button for 3 seconds to enter
standby mode. (In cleaning mode, pressing the ice making button (ON/
OFF) does not allow you to enter ice making mode directly, it only returns to
standby mode. By pressing the ice making button (ON/OFF) again, you can
enter the ice making mode).
In case of water shortage
Note: In the event of a water shortage, the water shortage indicator light will
remain on.
•
In case of water shortage, press the ICE MAKING (on/off) button once to
enter standby mode. Press the CLEANING button to enter cleaning mode.
The device returns directly to standby mode when water is scarce. Only after
refilling water again (both in the upper and in the lower water tank up to the
maximum mark) can the CLEANING button be pressed again to activate the
cleaning mode.
•
Werbung
