Hama SCRIBBLE Bedienungsanleitung Seite 5

• The product contains a rechargeable battery.
• Fully charge the product once before using it for
the rst time.
• Connect the supplied USB charging cable to the
USB connection (1) on the product.
• Connect the free plug on the USB charging cable
to a suitable USB charger.
• To do this, consult the operating instructions for
the USB charger you are using.
• The status LED (3) lights up solid red during
the charging process. Once the battery is fully
charged, the status LED (3) lights up green.
Note – charging process / battery
capacity
• A complete charging cycle takes about 90
minutes.
• The input stylus's rechargeable battery can be
charged both when it is switched on and off.
• If the battery capacity is less than 10%,
the status LED (3) ashes slowly blue and
after around 10 seconds switches itself off
automatically.
• The actual battery life will vary depending on
how you use the device, the settings and the
environmental conditions (batteries have a
limited life).
Note - Automatic switch-off
• Please note that the input stylus will switch
itself off after 5 minutes of inactivity.
Note - Damage to the display
To avoid damage to the display, please note the
following points:
• Avoid exerting excessive pressure on the
display with the input stylus.
• Ensure that the display and input stylus are
clean before use. Small pieces of dirt such as
grains of sand can cause scratches when the
input stylus is being used.
Note - Display protector / protective
glass
Using display protectors / protective glass can
lead to the function of the input stylus being
restricted.
• Press the On/Off switch (2) to switch the input
stylus on. The status LED (3) lights up solid blue.
• Press the On/Off switch (2) to switch the input
stylus off. The status LED (3) goes out.
5. Care and maintenance
Only clean this product using a lint-free, slightly
damp cloth and do not use any harsh cleaners.
6. Warranty disclaimer
Hama GmbH & Co KG assumes no liability and
provides no warranty for damage resulting from
improper installation/mounting, improper use of
the product or from failure to observe the operating
instructions and/or safety notes.
7. Technical data
Power supply
Current consumption
Battery type
Min. capacity
Typ. capacity
Weight
Dimensions L x Ø
System requirement -
Scribble function
Active "Scribble" input
stylus
5V / 1A
5 V 120 mA
Li-Po
130 mAh / 0.48 Wh
140 mAh / 0.52 Wh
14g
165 x 9 mm
- iPad OS14 or later
- Language support
3