Panasonic TY-CE42PS1 Installationsanleitung Seite 3

Components
Ceiling unit.......................1
Allen key..........................1
Cable tie ..........................2
Points to note during installation
•
This ceiling unit is for mounting a Wide Plasma Display to a ceiling for viewing purposes.
Do not use it for any type of installation other than ceiling mounting.
•
In order to ensure correct, problem-free operation of the Wide Plasma Display, do not
install the Display in any of the following places:
• Next to sprinklers or sensors
• Where it may be subject to vibration or shocks
• Near high-voltage wires or electric motors
• Where it may be in direct contact with air from heaters
•
When installing this ceiling unit, use a fixing method appropriate to the type of ceiling.
•
Insert the mains plug for the Wide Plasma Display into a mains socket which is close and
easily accessible.
•
Provide adequate ventilation so that the temperature around the display does not rise
above 40°C (104 F°). If there is insufficient movement of the air inside the display, heat
may build up inside the display and fire may result.
•
For U.S.A (TH-42PW3 / TH-42PWD3 only)
If the connection cable cannot reach the Display when it has been installed to the wall, use
the 15 m cable (TY-SCP15C03) which is sold separately.
Fixing bolt
Fixing bolt
(M8-12) ................2 (M8-20) ................2
Washer pan nut Spring washer
(M8)......................1
Insulating spacer Toothed pan washer
........................4
Fixing screw
(M5)......................2
Fixing bolt
........................1 (M8-100) ..............1
Pan head bolt with
........................4 hex socket (M8-45)
........................4
3