Werbung
Verfügbare Sprachen
Verfügbare Sprachen
6
Installing base covers L, R, and rear.
Insert them along the base.
Base cover L
Preventing equipment from falling over
After installing the stand, be sure to take special care to ensure that the Plasma Display will not fall over.
1
Attaching falling prevention bolts to the Plasma
Display.
2
Using strong cords or chains to stabilize it appropri-
ately and firmly to a wall, pillar, or other sturdy
element.
Perform this work in the same way on the left and right sides.
Note
Use falling prevention bolts, ropes,
chains, and fittings that are available
on the market.
Recommended bolts:
Nominal diameter M8
Length 12 to 15 mm (1/2 to 5/8 inch)
Base cover rear
Base cover R
12 to 15 mm
1
Falling prevention bolts
(1/2 to 5/8 inch)
2
Cord or chain
Fitting
Installation and assembly instructions
7
En
Werbung
